TFA Dostmann 30.3030.IT Manual De Instrucciones página 29

Battery replacement

Replace the batteries of the temperature station when the battery symbol
appears above the indoor temperature display.

When the batteries of the transmitter are used up, the low battery icon
appears above the outdoor temperature display.
Note:
In the event of changing batteries in any of the units, all units need to be reset by
following the setting up procedures. This is because a random security code is
assigned by the transmitter at start-up and this code must be received and stored by
the temperature station in the first three minutes of power being supplied to it.
SETTING UP:
Note: This temperature station receives only one outdoor transmitter.
First, insert the batteries into the temperature transmitter. (see "Install and
1.
replace batteries in the temperature transmitter").
2. Immediately after and within 30 seconds, insert the batteries into temperature
station (see "Install and replace batteries in the temperature station").
Once the batteries are in place, all segments of the LCD will light up briefly.
Following the time as 0:00 will be displayed and indoor temperature. If these
are not displayed after 60 seconds, remove the batteries and wait for at least
10 seconds before reinserting them.
3. After inserting the batteries, the temperature station will start receiving data
from the transmitter. The outdoor temperature and the signal reception icon
should then be displayed on the temperature station. If this does not happen
after 3 minutes, the batteries will need to be removed from both units and
reset from step 1.
28