Finishing Your Work; Maintenance And Care - Tornado EB 30/1 Manual Del Usuario

Ocultar thumbs Ver también para EB 30/1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Interrupting the work
see Figure 6
 Switch off the appliance; press the on/
off foot switch to do so.
 To ensure that the telescopic strut
stands safely during breaks in opera-
tion, hold it vertically; there is a stopper
that holds it in position.

Finishing your work

 Switch off the appliance when finished.
 Empty dirt container after each clean-
ing.
 Press the unlocking button of the bat-
tery and remove the battery.
 Charge the battery.
Emptying the dirt container
see Figure 7
 Unlock the dirt container and remove it.
 Empty the dirt container.
 Insert and lock into place the dirt con-
tainer.
Storing the appliance
 The appliance can be hung with the
handle; turn the handle if required (see
chapter "Install Telescopic strut and
handle and adjust the height").

Maintenance and Care

Caution
Remove the battery prior to any care and
maintenance work.
Cleaning the device
 Wipe the appliance using a damp cloth.
Do not use any aggressive agents,
such as cleaning powder.
6
Change/ clean the brush roller
see Figure 8
 Press the unlocking button and remove
the brush roller.
 Remove wound up hair using a knife or
scissors by moving the knife along the
defined cutting edge of the brush roller.
Remove loosened hair from the brush
roller.
 Insert the cleaned or new brush roller
and ensure that it sits properly.
The terms of the guarantee that is applica-
ble in each country have been published by
our respective national distributors. Any
fault that occurs with your appliance during
the guarantee period will be repaired free of
charge, provided that it has been caused by
a material or manufacturing defect. Guar-
antee claims should be addressed to your
dealer or the nearest authorized customer
service depot, and supported by documen-
tary evidence of purchase.
Troubleshooting
Charger display does not glow
 Check connection from charger to bat-
tery
 Check power supply of the socket.
Appliance does not clean properly
 Clean or replace the brush rollers (refer
chapter "Replace/ clean brush roller").
 Charge the battery (refer chapter
"Charging the battery).
Dirt is being thrown out of the appliance
 Empty the full dirt container (refer chap-
ter "Empty dirt container").
– 3
EN
Service
Warranty

Publicidad

Tabla de contenido
loading

Tabla de contenido