AEG PNEUMATIC 5000 E Instrucciones De Uso página 5

Positioning the
auxiliary handle
Displacing the
auxiliary handle
Setting the
depth gauge
Maintenance
ENGLISH
In order to re-position the auxiliary
handle loosen it as shown in illustration
and move to the required position.
Refasten handle.
The auxiliary handle can also be attached to the side of the housing. This
position may be preferred when drilling into the floor or into the ceiling, for
example.
Remove the auxiliary handle from the front position and screw it down at the
side of the machine.
1
For drilling to specific depth, slide the
depth gauge into the hole provided in the
handle and fasten it at the required drilling
depth.
The ventilation slots of the machine must be kept clear at all times.
If the carbon brushes cut-out or the hammer capacity declines please contact your
authorized AEG service station. This will ensure long service life as well as constant
readiness for working of the machine.
The location of your nearest service station is shown in our "Service adresses" leaflet
attached to each product.
Use only AEG accessories and spare parts. Should components need to be
replaced which have not been described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the ten–digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320,
D–71361 Winnenden.
4
2
PNEUMATIC 5000 E