Cebora WIN TIG GC 250 T Manual De Instrucciones página 29

Description
Amplitude of hot-start first current (ignition with
IH1
H00
HF)
IH2 Amplitude of hot-start second current (ignition
H01
with HF)
tH2 Duration of hot-start second current (ignition with
H02
HF)
Gradient of hot-start fitting with first welding cur-
SLO
H03
rent
IL1 Amplitude of hot-start current (ignition striking/
H04
lift)
tL1 Duration of hot-start current (ignition striking/lift)
H05
LOC Panel setting lock down (free, total, partial)
H06
UDJ UP/DOWN handling during JOBS (OFF=not acti-
H08
vated, 1=without roll, 2=with roll)
LIM Current level range extension up to 400%
H09
TPH Phase detection
H10
Select and
confirm the
p a r a m e t e r
to modify.
By adopting this method, it is possible to select, modi-
fy and confirm all the welding parameters which present
one after the other, and summarised in the following ta-
ble.
N.B The maximum adjustment value of the welding
current depends on the welding machine article.
Min DEF Max
0 120 220
5 40 220
0 7 250
1 50 100
5 25 100
0 150 200
PARTIAL FREE TOTAL
1 OFF 2
100 100 400
ON ON OFF
The param-
eter is acti-
vated in red;
then press
knob B.
Turn knob
B to set the
s e l e c t e d
parameter;
then press
to confirm
the setting.
Sol.
U.M.
A 1
A 1
ms 1
ms 1
A 1
ms 1
- -
- 1
% -
29