Remove The Access Cover; Connect Optional Devices - Hach 4-20 mA Manual Del Usuario

Figure 5 Electrical access ports
1 Power in (power cord only), no
ground plate. Do not use for
conduit.
2 Communication and network
modules (3x)
3 Communication and network
modules (8x)
4 Power in or out (conduit or power
cord), ground plate, communication
and network modules (8x)

Remove the access cover

Remove the access cover to connect to the wiring terminals. Refer to
Figure 6.
Figure 6 Access cover removal

Connect optional devices

Install the cables for output or input devices as shown in
sure to use the wire gauge that is specified for the connection. Refer to
Specifications on page 3. To configure a device, refer to the operations
manual.
Figure 7. Make
English 7