Graco SLIMFIT Manual De Instructiones página 15

5. Place Car Seat Rear-Facing
in Back Seat of the Vehicle
Place the base flat on the vehicle seat.
Push it back until the front of the car seat
touches the vehicle seat back. Center
the car seat between the lower LATCH
anchors.
6. Check the Level Indicator
Vehicle MUST be on level ground. Ball
must be completely in the blue zone.
Readjust the incline if needed. Or if
needed, rolled towels may be placed
under the car seat at the vehicle seat
crease, until the ball is completely in the
blue zone.
7. Connect LATCH Connectors
to Vehicle's Lower LATCH
Anchors.
LATCH strap should lay as flat as possible
and not be twisted.
8. Tighten the LATCH Strap
Press down firmly in the center of the car
seat while tightening the LATCH strap.
REAR-FACING
ORIENTADO HACIA ATRÁS
Ball MUST BE entirely in blue.
15 continue next page