Applying The Cuff - Walgreens WGNBPW-200 Manual Del Usuario

APPLYING THE CUFF

1. Remove all watches, wrist jewelry, etc.
prior to attaching the wrist monitor.
Clothing sleeves should be rolled up
and the cuff should be wrapped around
bare skin for correct measurements.
2. Apply cuff to left wrist with palm facing
up as shown in Fig. A.
3. Make sure the edge of the cuff is about
1/4"–1/2" (1cm–1.5cm) from the palm
as shown in Fig. B.
4. In order to ensure accurate
measurements, fasten the hook and
loop strap securely around your wrist
so there is no extra space between
the cuff and the wrist. If the cuff
is not wrapped tight enough, the
measurement values will not
be accurate.
5. If your physician has diagnosed you
with poor circulation in your left arm,
place the cuff around your right wrist
as shown in Fig. C.
NOTE:
• This device should not be used when
your wrist is wounded or injured.
• If it is not possible to use the cuff on
your left wrist, it can also be used
on your right wrist. However, all
measurements should be made using
the same wrist.
Fig. A
14
Fig. B
Fig. C