Display Symbols - Walgreens WGNBPW-200 Manual Del Usuario

Display Symbols:

Low Battery Symbol: Appears when batteries should be
replaced, or when +/- polarities have been positioned incorrectly.
Pulse Symbol: Shows heart rate in beats per minute.
Irregular Heartbeat Detector: Irregular heartbeat detected
during measurement. See page 19 for more information.
Risk Category Index: Indicates the blood pressure level.
START
See page 18 for more information.
STOP
Memory Average: Displays average of last 3 readings.
START
Excessive Body Motion Detector: Appears when
STOP
excessive body movement, especially of the wrist the cuff
is worn, is detected during the measurement. See page 20
for more information. NOTE: The measured blood pressure
reading may not be accurate if the icon is displayed.
If any of the following letters and numbers appear in the area
that systolic pressure should be displayed, an error has occurred
with your reading. See Troubleshooting section of this manual for
more information.
Incorrect cuff placement: Correct and measure again.
Error Determining Measurement Data: Relax, do not
move, and measure again.
Error Determining Measurement Data: Wrap the cuff
properly, keep steady, and measure again.
Pulse Signal Not Detected: Relax for 3 minutes, measure again.
System Error: Turn off monitor and measure again. If EE still appears
on the display followed by any other character (ex: EE4, EEA, etc.),
please contact Consumer Relations.
Pressure Measurement Out of Range: Switch the unit off
to clear, then measure again.
11