Adjusting The Alarm Time; Activating / Deactivating The Alarm; Reset Hole - Oregon Scientific Jumbo JM889N Manual Del Usuario

Adjusting the Alarm Time

Make sure that the Alarm Time is currently displayed on the
LCD screen.
Diagram Instructions
1. Press and hold the ALARM button for 2 seconds.
2. Adjust the hour of the Alarm Time. Press ALARM when
done.
3. Adjust the minute of the Alarm Time. Press ALARM
when done.
4. Adjusted Alarm Time now displayed.

Activating / Deactivating the Alarm

Diagram Instructions
1. LCD screen displays Alarm Time. If
the alarm is enabled. Otherwise it is disabled.
2. Press ALARM button to enable or disable the alarm.

RESET HOLE

If the clock behaves strangely or
stops responding, insert and press
a blunt stylus into the clock's Reset
Hole. The clock will then be reset
to its original factory setting.
9
is displayed,