Gas Connection; Parameter Setting - ims PRO PULSEMIG 220 C Manual Del Usuario

The differences between using the unit on steel or aluminum are:
- Use specific drive rolls for aluminium welding.
- Apply minimum pressure on the pressure rollers of the motor-driven reel to avoid crushing the wire.
- Use the capillary tube (designed to guide the wire between the drive rolls in the motor and the EURO connector) only for steel/stainless steel
welding (II-B).
- Use a torch designed for aluminium. This aluminium torch is fitted with a teflon torch liner in order to reduce frictions. DO NOT cut the liner at the
edge of the fitting! This liner guides the wire from the drive rolls.
- Contact tube: use a SPECIAL aluminium contact tube corresponding to the diameter of the wire.
When using red or blue liner (aluminium welding), it is recommended to use the part no.91151 (II-C). This
stainless steel liner guide improves the centering of the sheath and facilitates the wire feed.
SEMI AUTOMATIC WELDING WITH CUSI & CUAL (BRAZING MODE)
PULSEMIG can weld CuSi and CuAl wire from Ø 0.8 to 1.1 mm.
Just like with steel, the capillary tube must be in place and it must be used with a steel liner. In brazing mode, use pure argon gas (Ar).

GAS CONNECTION

- Fit a gas regulator on the gas cylinder. Connect it to the welding machine using the hose supplied. Put on the 2 clamps to avoid leaks.
- Ensure that the gas bottle is properly secured using the chain on the welding machine.
- Adjust the gas flow rate by adjusting the knob on the regulator.
NB: To facilitate the adjustment of the gas flow rate, start the motor by pressing the torch trigger (loosen the brake on the motor to avoid feeding
the wire through). Maximum gas pressure: 0.5 MPa (5 bar). This procedure does not apply to welding in «No Gas» mode.
GENERAL ORGANISATION OF THE INTERFACE

Parameter setting

• Information: all product information is available here (Model, S/N......)
• Process: choose the welding process: MIG-MAG, TIG or MMA.
• Settings: the advanced product settings are available here (display mode, device name,
language...)
1
• Calibration: allows you to start the calibration of the speed on the wire feeders.
• Portability: allows you to load or download JOBS from a USB key
as well as the machine configuration.
• Traceability: allows you to start saving all welding beads and exporting them to a USB
key.
Process : corresponds to the interface of the welding process in progress:
Process parameter: allows process settings,
1
2
At the various adjustment windows,
2
JOB: gives access to the different JOB reminder modes.
3
Process parameters: corresponds to the process parameter setting window:
• MIG-MAG (GMAW): Material/gas pair (Synergic welding parameters), wire diameter,
welding process (Manual, Standard, etc.), trigger mode.
• TIG (GTAW): electrode diameter, + to be seen
3
• MMA (SMAW): sub-process (Standard or Pulse), electrode type, anti-sticking, etc.
Energy: configuration of the energy mode, developed for welding with energy control
supervised by a DMOS (see chapter «ENERGY MODE»).
: corresponds to the program recall modes window:
4
• JOB: create, save, delete and recall JOB.
•QUICKLOAD: JOB recall using the trigger when not welding.
30
PULSEMIG 220 C / 220 C XL
:
EN
Video
1 2 3