Control Panel - Faber PAREO PLUS Manual De Instrucciones

USE
Button Function
L Turns the lights On/Off.
T1 Hood Down
Press for 2 seconds to raise the Hood.
Press briefly to turn the Motor On/Off.
Hood Up
Press once: The Hood lowers.
Press a second time: The Hood Stops.
When the movement has been completed
the motor turns on at Speed two.
The electronic control system recognises and signals two types of fault.
Led T1
Slow flashing
Rapid flashing
EN

Control panel

L
Current absorption threshold exceeded:
If an overload condition occurs, the fault is signalled by LED T1 on the
keyboard flashing once every 2 seconds. Check that nothing is blocking
normal hood movements.
The signal remains active until a new hood open/close command is given.
Hood opening safety microswitch tripped:
If the safety microswitch trips, the fault is signalled by LED T1 on the
keyboard flashing quickly (once every 250 ms). This means that the hood
has passed the microswitch........ Call Technical Assistance!
You can continue to use the hood's light and motor functions while this
fault is active. Whenever the motor is on, LED T1 will continue to flash,
indicating that the fault is still present.
T1
Display
-
On/Off
Off/Off
1
19
9