OHAUS Pioneer Manual De Instrucciones página 14

1.
Glass beaker
3.
Forceps
5.
Holder for floating solids
7.
Precision thermometer with holder
When making density measurements, the material should weigh at least 10.0 mg on an analytical balance and 100
mg on a precision balance.
Balance Preparation with Ohaus Density Kit (Optional)
Allow the balance to warm up sufficiently before making measurements.
Open either the left or right side door of the balance and remove the Pan as shown. Insert the Bracket into the
balance where the Pan was removed.
The Equalizing Washer is not used.
GlobalScientificSupply
www.
2.
Bracket
4.
Platforms
6.
Holder for non floating solids
8.
Sinker 10ml (optional equipment)
GLOBAL SCIENTIFIC SUPPLY
.com
The Laboratory Supply Company!
info@GlobalScientificSupply.com