OHAUS Pioneer Manual De Instrucciones página 19

3. Press the
sample. After completion of the test, press the
button to test a new sample.
1.
Press and hold the
appears. Press
2.
In determining density with the balance, the balance
setup and density determination procedures are basically
the same for a floating solid and a non-floating solid
except for the necessary holder (as shown in the figure)
to be used for density determination.
3.
After completion of the test, press the
button to test a new sample.
Lower the sample down into the liquid until it is fully
submerged.
1. Press and hold the
appears. Press
GlobalScientificSupply
www.
button to get the density of the
button until Density
to enter the Density Determination.
button until Density
to enter the Density Determination.
GLOBAL SCIENTIFIC SUPPLY
.com
The Laboratory Supply Company!
Holder for non-floating Holder for floating
solids
info@GlobalScientificSupply.com
solids