Jacuzzi Maxi Serie Manual De Instalación página 32

i
6
clock
pump 1
pump 2
blower
spotlight
i
7
I
SETTING THE TIME
For correct management of water filtering and use of the energy
savings mode, the current time must be set.
Press the "Clock"
time will be displayed, the hour digit will flash, and the respec-
tive symbol will appear on the display.
Use the "Up" and/or "Down"
Hold the keys down for rapid change.
Then press the "Clock"
start flashing.
Proceed as described above.
Press the "Clock"
exit the programming mode.
NOTES
- If no key is pressed for 5 seconds, you will exit the procedure
and any changes made will not be saved.
13.30
filtering cycle
adjustment
temperature
heater
saving
energy
panel lock
key for about 5 seconds. The current
keys to set the hour.
key to set the minutes, which will
key again to save the set values and
AM
- There is a back-up battery that keeps the time up-to-date even
when the system is powered off.
Displaying the time
To display the time, press the "Clock"
I
SETTING THE WATER TEMPERATURE
The water is heated by a tubular electrical heater. Do not set an
excessively high water temperature, i.e. over the limit of 40 °C.
The recommended temperature is 35-36 °C.
PLEASE NOTE!
The heater will be disabled if the pumps and/or blower are
turned on and the maximum permitted consumption is exceed
(the symbol will flash on the display). In this case, if you
need to heat the water, the system will enable the heater 5
minutes after consumption has decreased enough to allow it
to be switched on.
I
Temperature unit of measure
The temperature scale is set to °C. It can be changed to °F as
follows:
Press and hold the "Light"
until the message "cFn" appears.
If necessary, use the "Up"
scroll the menu until you see the message "cFn". Press the
"Light" key again to confirm the option.
Now insert the password 123 as follows:
- use the "Up" and/or "Down"
number.
32
key.
key for about 12 seconds,
and/or "Down" keys to
keys to insert the first