Jacuzzi Maxi Serie Manual De Instalación página 48

Pump and motor noisy
Water leakage from pump
shaft (rotating joint between
the pump and the motor)
The motor does not start
The motor stops
The blower (air compressor)
does not operate
Filters clogged
Water leaks on the suction line
Low water level
Motor bearings worn or
faulty
The impeller rubs against
Pump body
solid foreign bodies inside
the pump
Pump seal worn
or defective
No power
The mains switch is
triggered
Voltage too low
The residual current operated circuit
breaker (RCCB) is triggered
Incorrect or faulty connections
Shaft and impeller blocked
Motor windings burnt
Faulty contact on motor
start-up
The function has ended
Overload
Power supply cables
inadequate
No power
The button has not been fully
pressed
Two hydromassage pumps
are on
Clean the filters
Locate the leak and repair it
Add water up to the
normal level
*
*
*
*
Turn on the mains
Turn on the
Contact an electrician or
the electric power utility
Reset the RCCB
*
*
*
*
Press the relative button on the display once again
Leave the motor to cool and
the problem should disappear.
If it persists, see
Consult an electrician
Turn on the
Press the blower button
(air compressor)
Turn off a pump and
turn on the blower
48
switch
switch
*
main switch