Items Supplied; Fastening Tool; Examples Of Approved Fasteners For Drywall Applications; Noise Information And Vibration Values - Hilti BX 3-ME Manual De Instrucciones

3.8 Items supplied

BX 3-ME or BX 3-IF fastening tool, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
4 Technical data

4.1 Fastening tool

Weight in accordance with EPTA procedure
01/2003
Nail length (collated nails)
Nail length (single nails)
Nail diameter
Magazine capacity
Compression stroke
Contact pressure
Recommended maximum fastening rate
Rated voltage
4.2 Examples of approved fasteners for electrical, plumbing, heating and air-conditioning systems
installation applications
In conjunction with the X-FG B3-ME fastener guide the following fasteners are approved for electrical,
plumbing, heating and air-conditioning systems installation applications.
Nails for magazine mode
Nails for single-fastening mode
Threaded studs for single-fastening mode
Fastening electric cables

4.3 Examples of approved fasteners for drywall applications

In conjunction with the X-FG B3-IF fastener guide the following fasteners are approved for drywall
applications.
Nails for magazine mode
Nails for single-fastening mode

4.4 Noise information and vibration values

The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one power tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the power
tool. However, if the power tool is used for different applications, with different accessories or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This may significantly reduce exposure over the total
working period. Set out additional safety measures to protect the operator from the effects of noise and/or
vibration, such as: Maintaining the power tool and accessories, keeping the hands warm, reorganization of
work patterns.
Printed: 24.08.2016 | Doc-Nr: PUB / 5242878 / 000 / 03
3.8 kg
14 mm ... 24 mm
30 mm ... 36 mm
3.0 mm
20 nails
12 mm
50 N ... 70 N
500/h
21.6 V
X-S 14 B3 MX | X-P 17 B3 MX | X-P 20 B3 MX | X-
P 24 B3 MX
X-P 30 B3 P7 | X-P 36 B3 P7
X-M6-7-14 B3 P7 | X-M6-7-24 B3 P7 | X-W6-12-
14 B3 P7 | X-W6-12-20 B3 P7
X-EKB MX | X-ECT MX | X-ECH MX | X-EKS MX |
XEKS C MX
X-P 17 B3 MX | X-C 20 B3 MX | X-C 24 B3 MX
X-P 30 B3 P7 | X-P 36 B3 P7
English 21