Bronpi LORCA-C Insrucciones De Instalacion Y Del Operador página 17

Due to safety reasons during the transport, the baffle plate is not assembled. You will find it inside the combustion chamber. In order to place
it properly, you should follow the next steps:
Frontal models:
Moreover, the fireplace includes a metallic chimney trim in order to hide the
smoke pipes (see drawings D7 and D8). In no case may this piece act as
smoke pipe. It comprises two parts:
- a fixed part that must be placed on the upper part of the hood:
- a moving part (telescopic) of around 50 cm that is introduced into the
fixed part. This telescopic piece will be extracted until it touches the
ceiling. Then, screw it through the holes.
- The inside part of the combustion chamber is made of detachable cast
iron or vermiculite plates (see drawing D9) and the product should
never be used if these plates have been extracted. This fact would
invalidate the warranty.
"Cold hands" handle (Models: Lorca, Lorca-C, Lorca-R, Huelva, Vigo and
Marsella)
Inside the ash pan you will find the "cold hands" handle in order to open the
door. In order to place it properly, it is necessary to introduce it from top to
bottom and, later, rotate it (see drawing D10).
Double combustion
Some models of the metallic fireplaces include a double combustion. With this
system we get a second preheat entry air inside the combustion chamber.
This allows a second combustion of the gases not burnt in the first combustion
that achieves a high performance efficiency, a great fuel saving and reductions
in pollutant emissions. (see drawing D11)
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D4 D4
D7
D11
16
D5
D6
D8
Telescopic
grate
(Moving-
adjustable part)
Chimney trim
Fixed part
Corner models:
D9
D10
METALLIC FIREPLACES