Sony VPH-G70Q Manual De Instalación página 30

Using the Signal Interface Switcher
When the switcher is connected to the projector using the 5BNC cables (5BNC mode 2)
15 K RGB/HD/
Component
equipment
30
(EN) Connections
When the switcher to be connected is more than 50 m away from the
projector, or the SIC-M or CCQ-BRS cable cannot be used for the
connection between the projector and switcher, connect the RGB signal
sources to the switcher and the video signal sources to the projector.
REMOTE
RS-422A
INPUT A S VIDEO TRIGGER CONTROL S
R
R-Y Y IN
P R
G
C IN
Y
B
B-Y
IN
P
B
IN
ABL LINK
SYNC PLUG IN INDEX
OUT
POWER
HD
IN
OUT
VIDEO
VD
OUT
IN
OUT
VIDEO IN
CONTROL
S IN
Remote
5BNC cables
control cable
(supplied)
to MONITOR
to CONTROL S
OUT
OUT
PC-1271/1271M
Switcher
Computer Computer
Setting up
• Set INPUT-A to RGB and 5BNC MODE to ON in the SET SETTING
menu.
For details, see "The SET SETTING Menu" on page 51 (EN).
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control or by setting VIDEO in the INPUT SELECT menu.
For details, see "The INPUT SELECT Menu" on page 45 (EN).
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
• When the HDTV signal is input to the switcher, set the output of the
connected equipment or the IFB-1301 Signal Interface Board installed to
the switcher to GBR OUT.
• When the component signal is input to the switcher, set the output of the
connected equipment or the IFB-1200 Signal Interface Board installed to
the switcher to RGB OUT.
Rear
S VIDEO IN
to S video
to video
output
output
Video
equipment
MAIN POWER
OFF ON
AC IN
100~120V 15A 250V
200V~240V T6.3A 250V
AC IN
AC power cord (supplied)
to a wall outlet