Sony VPH-G70Q Manual De Instalación página 34

Ocultar thumbs Ver también para VPH-G70Q:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connecting Multiple Projectors
34
(EN)
Connections
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable correctly.
• You can extend the SIC-M or CCQ-BRS cable between the switcher and the
first projector up to 50 m.
• The video signal input to the signal interface board installed to the INPUT B
section should not exceed 70 MHz. When projecting the video signal which
exceeds 70 MHz, connect the signal source to the INPUT A connectors using
the 5BNC cables.
Setting up
• Set INPUT-A to RGB and 5BNC MODE to ON in the SET SETTING
menu.
For details, see "The SET SETTING Menu" on page 51 (EN).
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
• To control the projectors using the index number, set the sequential
number from 01 to 08 on each projector using the INDEX NO. switches
on the rear panel.
• Set the MODE selector on the IFB-40 installed to the first projector to
the appropriate position according to the length of the SIC-M or CCQ-
BRS cable between the first and second projectors.
For details, see "Location and Function of Connectors" on page 23 (EN).

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vph-g70qm

Tabla de contenido