Adjusting the Registration
Adjusting the Registration
Procedure
66
(GB)
Adjustments
1 Mark the center of the screen.
v
2 Set the remote control to the service adjustment mode.
(page 35 (GB))
v
3 Select NO INPUT mode.
v
4 Select the internal oscillation pattern to be used for the registration
adjustment.
(page 67 (GB))
v
5 Reset the registration data to the factory preset levels. (Only if the
adjustment data has been modified before)
v
6 Adjust the green registration.
1 CENT adjustment
2 SIZE and LIN adjustments
3 SKEW and BOW adjustments
4 KEY and PIN adjustments
5 KEY BALANCE and PIN BALANCE adjustments
v
7 Adjust the red registration.
1 CENT adjustment
2 SIZE and LIN adjustments
3 SKEW and BOW adjustments
4 KEY and PIN adjustments
5 KEY BALANCE and PIN BALANCE adjustments
6 ZONE adjustment
v
8 Adjust the blue registration.
1 CENT adjustment
2 SIZE and LIN adjustments
3 SKEW and BOW adjustments
4 KEY and PIN adjustments
5 KEY BALANCE and PIN BALANCE adjustments
6 ZONE adjustment
v
9 Save the adjusted data as the standard data.
v
!º Adjust fine for each input signal.
1 Adjustment of video input signal
2 Adjustment of RGB input signal
3 White balance adjustment
v
!¡ Activate the protection of the remote control.
v
!™ Adjust the picture.
(page 102 (GB))
v
Complete
(page 67 (GB))
(page 67 (GB))
(page 99 (GB))
(pages 69 (GB) to 77 (GB))
(pages 78 (GB) to 86 (GB))
(page 87 (GB))
(page 88 (GB))
(pages 89 (GB) to 95 (GB))
(page 101 (GB))