Fine Adjustment For Each Input Signal; Adjusting The Video Input Signal; Fine Registration Adjustment - Sony VPH-D50HTU Manual De Instalación

Fine Adjustment for Each Input Signal

Adjusting the Video Input Signal

Fine registration adjustment

After the registration adjustment is performed without an input source and
the adjustment data is saved as the standard data, input an external signal
and fine adjust for each input signal.
1
Input the video signal to the VIDEO IN connector on the projector or to
the signal interface board installed to the INPUT B section.
2
Select the video input source by pressing the INPUT SELECT VIDEO
and SELECT keys or the INPUT SELECT B key on the remote control.
3
Display the INPUT INFO menu to check that the horizontal frequency
of the input signal (fH) indicates 15.7 kHz.
To display the INPUT INFO menu, press the MENU key, select INPUT
INFO with the V or v key, then press the ENTER key.
1
Press the PATTERN key to display the CROSS HAIR pattern.
2
If necessary, fine adjust the registrations.
For details of the adjustment procedure, see "Adjusting the Registration" on
pages 66 (GB) to 87 (GB).
3
Press the MEMORY key and release it to save the adjustment data.
Note
Do not hold down the MEMORY key in step 3.
89
Adjustments (GB)