Standby Mode; Measurement Mode - OHAUS MC2000 Manual De Instrucciones

MC2000 Moisture Analyzer Series
1.
2.
3.
4.
5.
3.3.2

Standby Mode

When the instrument is installed batteries and the display is off, the device is
in Standby mode.
Start
Stop
3.3.3 Category Mode
Category
Up
Down
Category
3.3.4

Measurement Mode

Category
Up
Up
Down
Enter
Please remove any dirt, sand or metal impurities from the
sample before starting the test.
In order to get accurate results, please ensure that the sample
and instrument are at the same temperature level.
In order to get accurate results, for large particle size sample
(for example corn), please test several times and get the
mean value.
In order to get accurate results, please clean the container
after each test. Especially for high moisture level
samples.
In order to get accurate results, please fill the whole container
with sample.
(Short press) Turns on the display, self-check and enters
category mode. The category code is showed on the display
"C##".
(Long press) Re-enters standby mode. (off)
(Short press) Changes modes to load category, show "C##"
on display.
(Short press) Select the category code.
(Short press) Select the category code.
(Short press) Load category parameter and exit to
measurement mode.
(Short press) Changes modes to measurement, show
"0.0%" on display.
(Short press) Shows sample weight value (after moisture
measurement)
(Press twice) Shows the density of sample (after moisture
measurement)
(Short press) Shows the temperature value of sample (after
moisture measurement)
(Short press) Shows mean moisture value and delete the
previous measurement result (after at least two
measurements)
EN-5