System Requirements; Ethernet Interface; Technical Data; Interface Installation - OHAUS RS232 Manual De Instrucciones

RS232-Ethernet Interface
INTRODUCTION
The OHAUS RS232-Ethernet Interface Kit is a unique solution that allows the user
to connect a balance to the Ethernet. It can be used with OHAUS products that
have the RS232 interface.

SYSTEM REQUIREMENTS

 Ethernet Interface

Compliance: IEEE 802.3 compatible

Connector: RJ-45
 RS232 Interface
This Kit uses a male DB9 connector. Pin assignments are shown in the
following diagram:
 Technical Data

Indoor use only

Operating Temperature: 0 to 40° C

Storage Temperature: -10 to 55° C

Ambient Relative Humidity: maximum relative humidity 80 % for
temperatures up to 30° C, decreasing linearly to 50% relative humidity at
40° C, noncondensing

Altitude: Up to 2000 m

Power Input: 12VDC 0.5A

INTERFACE INSTALLATION

Power on the Kit by connecting the power adapter. Plug the RS232 connector of
the kit into the female RS232 connector on the balance. The RS232 configuration is
set to 19200-8-N-1, handshake is None. Another RJ-45 connector can be
connected to a Local Area Network by a network cable.
DB9 (Male) Pin RS232
1 Reset
2 RxD (in)
3 TxD (out)
4
5 GND
6
7
8
9
EN-1
N/A
N/A
N/A
N/A
N/A