Ethernet Configuration - OHAUS RS232 Manual De Instrucciones

EN-2

ETHERNET CONFIGURATION

CAUTION:
Invalid or incorrect Ethernet parameters may impact your network
system or lose network connectivity. Please check with your network administrator
before use.
To set the Ethernet parameters with web browser
1. Make sure the Ethernet Interface Kit is installed properly and network cable is
connected to a computer (PC).
2. Set the PC to obtain an IP address automatically as shown below.
3. Open the IE Browser and enter the default IP address of the Ethernet
Interface Kit "169.254.1.1" (
show below page:
4. Click the "Network Configuration" on the left side, and input the user name
and password. Then click "OK" to proceed.
5. Input the Ethernet parameters in the following page, click "Save Config" to
save the changes.
RS232-Ethernet Interface
), the browser will
User: ohaus
Password: ohaus