OHAUS RS232 Manual De Instrucciones página 5

RS232-Ethernet Interface
Note:

To use DHCP, enable the DHCP:

To use static IP address, disable the DHCP:
Ethernet configuration parameters.
Ethernet Connection
The Interface has a default static IP Address, 169.254.1.1, and can be changed by
following above steps.
The Port Number is always 9761 and cannot be changed.
Configuration reset
It is recommended to record the IP address since the Ethernet Interface Kit can
only set parameter per web by IP address. In case the IP address is lost, it can be
reset to the factory setting by following below steps.
1. Power off the kit.
2. Short Pin 1 of RS232 connector to the shield with tweezers or other conductive
material.
3. Power on the kit. After 5s, remove the tweezers or other conductive material
used. The kit is now reset to the factory configuration.
DIMENSIONS
ACCESSORIES
For a complete listing of Ohaus printers and other accessories, contact Ohaus
Corporation or visit www.ohaus.com.
Shield
Pin 1
EN-3
and then set the