Specifications; Operation; Battery Information - Sunoptic Surgical LED Rover IV+ Instrucciones De Utilizacion

4. SPECIFICATIONS

Item
Lamp Type
Color temperature
Battery
Current converter output 800 milliamps (nominal)
Endurance time (Default
Software)
Model
Dimensions
Weight
Electrical Protection
Medical Classification
Port
Operating Environment
Storage Environment

5. OPERATION

The LED Rover IV+ is operated by a pushbutton switch inside a protective silicone rubber
boot at the back end of the handle. It features a momentary ON function with partial
depression of the switch, and clicks to stay ON with full depression. Depress the switch fully
again to turn it off.
6.

BATTERY INFORMATION

6.1 RECHARGEABLE BATTERY
The rechargeable batteries provided are high capacity 18650 3.7 volt Lithium-ion
battery. The battery charger provided is compatible only with the 3.7 volt high capacity
rechargeable Lithium-ion batteries that are supplied. The 3.7 volt high capacity batteries
provided are compatible only with chargers specifically designed for them. Do not put
attempt to charge the batteries with another type of charger.
A fully-discharged battery may require approximately eight hours to reach a full charge.
The three indicator lights on the charging cradle will be blank when there is no battery
in the cradle. The charger will flash one LED while determining what configuration of
battery is in the charger and this LED will remain solid once the configuration is
determined. The second and third LEDs will flash while it is charging, and there will be
three solid lights when the battery is fully charged. Batteries may be "topped off" to full
charge even if they are not fully discharged. Batteries may be left in the charging cradle
when charged. Avoid directly short circuiting a battery. The power converter operates
on 100∼240 VAC, 50∼60Hz @ 0.25A.
With fully charged batteries the light source is approximately 2.5 hours with the strongest
brightness, followed by approximately ½ hour of usable light.
LIT-226 Sunoptic Technologies
Rev. B
Specification
LED
5000 K (nominal)
Lithium Ion 18650 3.7V
High 2.5 hours (typical, actual endurance may vary)
Medium 4.5 hours (typical, actual endurance may vary)
Low 15 hours (typical, actual endurance may vary)
LED Rover IV+
Max Length: 4.9", Max OD: 1.125"
0.32 lbs 145g
[ ]
Class I, Type BF
FDA Class II
Europe Class I
ACMI
Temperature +0° to +30° C (32° to 86° F)
Relative Humidity 0 to 85%rh, non condensing
Air Pressure 700 to 1060 hPa
Temperature -20° to +60° C (-4° to 140° F)
Relative Humidity 30 to 95%rh, non condensing
Air Pressure 700 to 1060 hPa
®
Page 5 of 35
(English)