DeLonghi DOLCE VITA ELETTRICO Manual De Instrucciones Para El Uso página 25

The room stays cold.
Leaks of the liquid in the
appliance.
The appliance does not
respond correctly to orders
received from the Pilot Wire
control unit.
The appliance keeps on
heating despite the window is
open and the "Open Window"
function is active.
The appliance does not resume
heating after the window is
closed and the "Open Window"
function is active.
The display shows "ALL".
8. GUARANTEE
You are recommended to keep all parts of the pack-
aging in case the appliance needs to be returned to
the dealer. The appliance must arrive complete and
undamaged in order to maintain the validity of the
guarantee.
The Manufacturer guarantees customers all the rights speci-
rights recognised by national legislation.
production defects present at the moment of sale or becom-
ing evident within two years from the date of purchase and
gives the customer the right to free repair of the defective
product or replacement should repair be impossible.
The above rights are invalidated in the following cases:
-
in the instructions, which are an integral part of the
sales contract;
- defects caused by accidental breakage, negligence
or tampering.
Operations involved in installation, connection to the house-
hold mains and maintenance described in these instructions
are not covered by the guarantee.
The Manufacturer declines all liability for damage or injury
Make sure the power of the appliance is adequate for the room to be heated.
heat to the required temperature (setting the radiator to maximum does not raise the tem-
perature more quickly).
Turn the appliance off and contact your local dealer.
liquid.
Disconnect the appliance from the mains power supply (switch off the mains switch by
moving it in the "O" position). Make sure the connection is correct (Fig.8) and the control
unit is functioning correctly.
It may be necessary to wait a few minutes before the function starts operating.
vate the function.
Check that the positioning of the appliance comply with the requirements referred to in
ch. 4.3.2 of this booklet.
Check that the area around the appliance Command is free of any obstacles.
It may be necessary to wait a few minutes before before the sensor detects the window
closing.
Check that the area around the appliance Command is free of any obstacles.
Deactivate and activate the function again.
Should the response time of the function be too long, you can always start the appliance
manually.
The temperature sensor is malfunctioning. Turn off the appliance and contact your dealer.
23
caused directly or indirectly to people, objects or pets as a
result of the failure to apply these instructions, with particular
reference to warnings regarding installation, start-up and use
of the product.
her dealer and present a valid proof of purchase issued by the
seller, complete with date of purchase.
9. DISPOSAL
Make sure the power cable is disconnected from
the power line before performing any operation.
To remove the appliance, follow the procedure for
the towel warmer must be carried out in accordance with
the legislation in force for the disposal and management of
waste.
Important information for correct disposal of
the product in accordance with EC Directive
2012/19/EC.
GB
-