Migatronic CAR-O-LINER CMI 161 Guía De Usuario página 11

Connection and operation
Inching
The function is used
for wire inching e.g.
after change of wire.
Wire inching starts by
pressing the green key
pad and simultaneously
triggering the torch trigger. Wire inching continues
even though the green key pad has been released.
It does not stop until the torch trigger has been
released again.
Change of wire liner
Selecting welding polarity
Polarity reversal is recommended for certain types
of welding wire, in particular Innershield welding
wire. For recommended polarity, please refer to the
welding wire packaging.
Change of polarity:
1. Disconnect the machine from the mains supply.
2. Dismount the milled nuts at the poles (fig. 1).
3. Reverse the cables (fig. 1).
4. Mount the milled nuts (fig. 1).
5. Exchange earth cable from minus to plus (fig. 2).
6. Connect the machine to the mains supply.
1
Change of polarity
Switch on, press, weld
CMI
Welding program setting
Cu
CrNi 1.0
• Switch on the welding machine on the main
Al
0.9
Fe Mix 0.8
Fe CO 0.6 switch (2)
2
• Select process
• Select type of material and wire diameter
• Set one of the following parameters:
welding current, wire feed speed or thickness of
material
• Trim the arc length, if required
• Adjust secondary parameters.
• The machine is now ready to weld
Software reading
• Insert the SD-card
in the slide in the
right side of the
machine.
• Turn on the
machine.
• The display flashes
shortly with three
lines.
• Wait until the set current is displayed.
2
• Turn off the machine and remove the SD card.
• The machine is now ready for use.
It is necessary to read software inside the new
control unit by means of a SD card, if the control
unit has been exchanged.
CMI
Cu
CrNi 1.0
Al 0.9
Fe Mix 0.8
Fe CO 0.6
2
Please read your quick-
guide
WARNING
Voltage is present on the welding
wire when pressing the welding
hose trigger.
11