Workpiece Support; Auxiliary Fence - RIDGID MS1050 Manual Del Propietário

Workpiece Support

Long pieces need extra supports. The supports should
be placed along the workpiece so the workpiece does not
sag and your hand holding the workpiece is positioned 4"
or more from the blade path. The support should let the
workpiece lay flat on the base and work table during the
cutting operation.
NOTE: When mounted on a large flat surface, the miter
saw table is 3" high. Two finished 2x4's on their sides can
be used as work support extension.

Auxiliary Fence

Certain types of molding need a fence face extension due
to the size and position of the workpiece. Slots are pro-
vided in the fence to attach an auxiliary fence.
21