Assembling Extensions And Stop Block - RIDGID MS1050 Manual Del Propietário

Assembly (continued)

Assembling Extensions and Stop Block

Find the following parts:
Item
No. Description
A Extension Arm ..........................................................2
B Clamp Bracket ..........................................................2
C Dust Bag...................................................................1
D Thumb Screw 1/4 x 20 x 1/2.....................................1
E Phillips Screw 5/16-18x1-1/4 ....................................2
F Washer 21/64 x 5/8 x 1/16........................................2
G Adjustable Stop Block...............................................1
1. Place saw in the 0° miter position.
2. Lock the miter saw power head in the lowered posi-
tion.
3. Tilt saw back on its rear legs to expose underneath of
base. Secure saw so it does not tip or fall off bench.
4. Slide adjustable stop block over the back of side
extension arm. Thread the 1/4-20 thumb screw into
the back of stop block.
5. Find the second pair of grooves underneath miter
saw base. Place clamp bracket over extension arm.
NOTE: Each extension arm must pass completely
through both grooves in the saw base before the
clamp bracket is secured.
6. Secure extension arm in place with a 5/16-18 x 1-1/4
Phillips screw and a flat washer as shown. Do not
overtighten. Overtightening may damage the saw.
7. Repeat steps 1-8 for the other side of the miter saw,
omitting step 4 if already performed.
8. Set the saw back down.
9. Set the stop block at the desired location and tighten
thumb screw.
A
Qty.
D
Extension
Arm
Clamp Bracket
1-1/4" Phillips Screw
Flat
Washer
Pull bars up into base grooves with
10
C
B
E
F
Stop
Block
1/4-20
Thumb Screw
Top View
Clamp
Bracket
clamp using screw
G