Care & Cleaning - Sage the Barista Express BES875 Guía Rápida

Care & Cleaning
REPLACING THE WATER FILTER
1 2 2
Set current month Soak lter
for 5 min
The provided water filter helps prevent scale
build-up in and on many of the inner functioning
components. Replacing the water filter after
three months or 40L will reduce the need to
descale the machine.
The limitation of 40L is based on water hardness
level 4. If you are in level 2 area, you can increase
this to 60L.
CLEANING CYCLE
The CLEAN ME light will illuminate when a
cleaning cycle is required. This is a back-
flushing cycle and is separate from descaling.
1. Insert the 1 CUP filter basket into the
portafilter, followed by the supplied cleaning
disc, followed by 1 cleaning tablet.
2. Lock the portafilter into the group head
and place a large container beneath the
portafilter spouts.
3. Ensure the water tank is filled with cold water
and the drip tray is empty.
4. Press the POWER button to switch the
machine off.
5. Press the 1 CUP and 2 CUP buttons
simultaneously, then also press the POWER
button. Hold all 3 buttons together for
approximately 10 seconds.
6. The cleaning cycle will commence and last
for approximately 5 minutes. During this
time, water will intermittently flow from the
portafilter spouts. Once complete, 3 beeps
will sound.
7. Remove the portafilter and ensure the tablet
has completely dissolved. If the tablet has not
dissolved, repeat until the tablet has dissolved.
14
3 4
Install lter in tank
Ensure parts are
connected
DESCALING
After regular use, hard water can cause mineral
build up in and on many of the inner functioning
components, reducing the brewing flow, brewing
temperature, power of the machine, and taste
of the espresso.
1. Even if you are correctly using the water filter
Do not immerse power cord, power plug
or appliance in water or any other liquid.
The water tank should never be removed
or completely emptied during descaling.
Priming machine for descaling function
2. Dissolve one Sage Descaling powder
3. Press and hold the 2 CUP button and
5
Install water tank
provided, we recommend you to descale when
you see scale build-up in the water tank.
WARNING
sachet into one litre of water then fill the
water tank.
then press and hold the POWER button
simultaneously to enter the Descale mode.
The unit will heat up as part of commencing
the descaling action, during the heating
processes the POWER button should flash
continuously. The machine will indicate it
is ready for descaling when the POWER
button, 1 CUP button, CLEAN ME indicator
and HOT WATER / STEAM indicator are all
illuminated (solid on).
!
Replace lter after
90 days or after 40L