Functions; Installing The Water Filter; First Use - Sage the Barista Express BES875 Guía Rápida

Functions

INSTALLING THE WATER FILTER

• Remove the water filter and water filter holder
from the plastic bag.
• Soak the filter in cold water for 5 minutes.
• Wash the filter holder with cold water.
• Set the reminder for next month of replacement.
We recommend to replace the filter after
3 months.
• Insert the filter into the two parts of the
filter holder.
• To install the assembled filter holder into the
water tank, align the base of the filter holder
with the adapter inside the water tank.
Push down to lock into place.
8
• Fill the water tank with cold water before sliding
back into position at the back of the machine
and locking into place.

FIRST USE

• Ensure the water filter is securely fitted inside
the water tank.
• Fill the water tank with cold, preferably filtered
water up to the MAX mark.
• Ensure the hopper is locked into position.
• Plug the power cord into a 230V power outlet.
Press the POWER button to switch the machine
on. The POWER button light will flash while the
machine is heating.
NOTE
If the hopper is not correctly locked into position,
the FILTER SIZE LED's will flash.
1. Press 2 CUP button to run hot water through the
group head.
2. Position the steam wand tip over the drip tray.
Rotate the STEAM / HOT WATER dial to the
STEAM position and run steam through the
steam wand for 10 seconds.
3. Rotate the STEAM/HOT WATER dial
to the HOT WATER position and run water
through the hot water outlet for 10 seconds.
4. Repeat steps 1-3 until the water tank is empty.