Graco Snugfix Manual Del Propietário página 13

Adjusting the height of the
Shoulder Straps
Locate the Metal Junction
9
Plate (16) underneath the seat.
Release the two loops.
Turn the seat around and pull
10
the Shoulder Straps through the
Seat Back and pull the Body
Support forward.
DO NOT PULL THE STRAPS
ALL THE WAY THROUGH THE
BODY SUPPORT
Locate the suitable slot in the
11
back of the seat. The Back
section of the Body Support will
move up and down automatically
to align with the slot.
Turn the seat around again and
12
pull the straps through.
Rethread the straps down the
13
back of the seat and re-attach
to the Metal Junction Plate. Pull
the Harness Adjustment Strap to
tighten the Shoulder Straps.
IMPORTANT:
MAKE SURE THAT THE
STRAPS PASS THROUGH THE
SLOTS ON THE BACK OF THE
SEAT BEFORE ATTACHING
THE METAL JUNCTION PLATE.
For a smaller baby, use the
14
lower shoulder slots and the
upper strap loops.
The ends of the straps must hang
15
in front of the junction plate.
Lift up the strap ends to
16
check that the loops are
completely within the junction
plate slots and pull on the straps
to be sure they are secure.
EN
G B
For a larger baby, use the upper
17
shoulder slots and the end strap
loops.
Check that the straps are
completely within the junction
plate slots and pull on the straps
to be sure they are secure.
WARNING: Use extreme
care in threading the straps
according to the diagram. If the
straps are not secure, they will not
protect your baby.
13