Mount To Cabinet; Check The Installation - Bosch HBE5452UC Manual De Instalación Y De Usario

Electrical Connection
The four-wire connection is preferred, but where local
codes permit, the three wire connection is also
acceptable.
Four-wire Connection
Ungrounded Neutral
Connect the red oven wire to the red electrical supply
▯
wire (hot wire).
Connect the black oven wire to the black electrical
▯
supply wire (hot wire).
Connect the green ground oven wire to the bare or
▯
green ground electrical supply wire.
Three-wire Connection
Grounded Neutral
Connect red wire from oven to red wire in junction box.
▯
Connect black wire from oven to black wire in junction
▯
box.
Connect green ground wire from oven to white, green
▯
or bare neutral wire in junction box.
The conduit cable, where connected at the oven, swivels.
Rotate conduit cable upward (or downward) and direct
through hole prepared in cabinet to attach to junction
box.
To maintain serviceability, the flex conduit must not be
shortened and should be routed to permit temporary
removal of the oven.

Mount to cabinet

NOTICE: Before installing the appliance, be sure to
verify the cabinet dimensions and electrical connections.
Note: The appliance is heavy. It is advisable to install it
with a second person.
Fully insert the appliance and center it.
1.
NOTICE: Connection lines and cables must not kink
or come into contact with sharp edges.
Secure the appliance to the cabinet using 2 screws.
2.
The gap between the countertop and appliance may not
be sealed by additional strips.
Thermal insulation strips may not be fitted to the side
panels of the surround unit.

Check the Installation

WARNING
9
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
Switch on the circuit breaker.
Verify that elements function properly.
9