The drive system lever for the front axle for R 316TX
AWD, R 316TsX AWD is found behind the left front
wheel.
To lift and lower the cutting deck
To lift the cutting deck to transport position, pull the lift
lever rearward. If the engine is on, the blades stop to
rotate automatically.
To lower the cutting deck to mowing position, press the
lock button and move the lift lever forward. If the engine
is running, the blades start to rotate automatically.
To start the engine
1. Make sure that the drive system is engaged, see
engage and disengage the drive system on page 15 .
16
2. Lift the cutting deck and apply the parking brake.
3. Move the throttle control to the middle position.
4. If the engine is cold, move the choke control fully
rearward.
5. Turn the ignition key to the start position.
To
2
1
844 - 009 - 25.11.2021