Tabla De Contenido; Explanation Of Symbols And; Safety Warnings; Chain Saw Components - EMAK GSH 510 - MTH 5100 Manual De Instrucciones

TRANSLATION OF ORIGINAL INSTRUCTIONS
INTRODUCTION
For correct use of the machine and to avoid
accidents, do not start working until you have
read this manual carefully. You will find
explanations concerning the operation of the
various parts plus instructions for necessary
checks and relative maintenance.
NOTE: The descriptions and illustrations
contained in this manual are not binding. The
manufacturer reserves the right to undertake
any modifications it deems necessary without
revising this manual.
In addition to the operating instructions, this
manual contains paragraphs that require your
special attention. Such paragraphs are marked
with the symbols described below:
WARNING: where there is a risk of an accident or
personal, even fatal, injury or serious damage to
property.
CAUTION: where there is a risk of damaging the
machine or its individual components.
WARNING
RISK OF HEARING DAMAGE
IN NORMAL CONDITIONS OF USE, THIS MACHINE
MAY EXPOSE THE OPERATOR TO A PERSONAL DAILY
NOISE LEVEL EQUAL TO OR HIGHER THAN
85 dB (A)
CONTENTS
1. EXPLANATION OF SYMBOLS AND
SAFETY WARNINGS _______________ 25
2. CHAIN SAW COMPONENTS _________ 25
3. SAFETY PRECAUTION _____________ 26
4. FITTING THE BAR AND CHAIN _______ 27
5. STARTING _______________________ 27
6. STOPPING THE ENGINE ____________ 30
7. USE ____________________________ 30
8. MAINTENANCE ___________________ 32
9. STORAGE ________________________ 35
10. TECHNICAL DATA _________________ 37
11. DECLARATION OF CONFORMITY ____ 38
12. WARRANTY CERTIFICATE __________ 39
13. TROUBLE SHOOTING CHART _______ 40

1. EXPLANATION OF SYMBOLS AND

SAFETY WARNINGS (Fig.1)
1. Read operator's instruction book before
operating this machine.
2. Wear head, eye and ear protection.
3. Type of machine: CHAIN SAW.
4. Guaranteed sound power level
5. Serial number
6. CE conformity marking.
7. Year of manufacture
8. Primer bulb
9. Chain brake, activated (right). Chain brake,
not activated (left).
2. CHAIN SAW COMPONENTS (Fig. 2)
1. Choke lever
2. Throttle trigger
3. Throttle trigger lockout
4. Carburetor adjustment screws
5. Inertial brake lever
6. Exhaust muffler
7. Chain
8. Guide bar
9. Air filter cover
10. On/off switch
11. Fuel tank cap
12. Starter handle
13. Oil tank cap
14. Primer bulb
15. Lateral chain tensioner screw
16. Front handle
17. Rear handle
18. Bar cover
I
GB
F
D
E
NL
P
GR
TR
CZ
SK
RUS
UK
PL
H
LV
EST
LT
RO
25