Putting Into Operation; Filling The Tank - Boneco U200 Instrucciones Para El Uso

Putting into operation

• Do not place it directly next to a radiator or on a
floor with floor heating. The moisture of the mist can
damage the floor surface (6 and 7) (see Safety
Instructions).
• The mist outlet must not be pointed directly at plants or
other objects. Keep a distance of at least 50 cm) (12).
• Please observe the accompanying instructions for
starting the A250.
• Read the instructions under "Filling the tank"
for filling the water tank.
• Place the water tank onto the base (15).
• Connect the adapter to the unit and the electrical socket
and switch on the unit using the rotary switch (16).
• The appliance will reach full capacity about
10 –15 minutes after being switched on.
• Make sure that the power cord is not pinched
anywhere. Do not operate the appliance if the
cord is damaged (2).

Filling the tank

Always switch off the appliance before removing
the water tank. Do not reach inside the nebulizer
space while the appliance is running!
To protect health safety and proper humidi-
fier function use only clean, contamination-
free, cold, fresh tap water in your humidifier. If
your water source is contaminated or if you are
uncertain of its safety use distilled water.
Do not operate the appliance when the water
tank is empty! When the water reaches the mini-
mum level, the unit switches off automatically.
• Make sure that there are no foreign objects inside
the water tank.
• Remove the water tank cap from the tank (13).
Fill the tank with clean, cold tap water (14).
Close the cap of the water tank securely! Place the
water tank onto the base (15). Do not add any
additives to the water!
• Connect the adapter to the unit and the
electrical socket and switch on the unit using
the rotary switch (16).
11
12
13
en
19