Putting Into Operation; Description Of The Appliance; Filling The Tank - Boneco U7144 Manual De Instrucciones

Ocultar thumbs Ver también para U7144:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 56
Unpacking
• Carefully remove the unit from its box.
• Remove the unit from the plastic bag.
• Warning: the mist outlet is packed in a red bag inside
en
the box insert. Make sure that you remove the mist
outlet from the packaging.
• Review the information given on the rating plate about
the mains supply.
• Use the original packaging for storing the appliance if
you do not use it all year round.

Putting into operation

Find the ideal location for your appliance:
• Do not place it directly next to a radiator or on a floor
with underfloor heating. The moisture in the mist can
damage the floor surface (6 and 7) (see Safety Ins-
tructions).
• The mist outlet must not be pointed directly at plants
or other objects. Keep a distance of at least 50 cm)
(10).
• Soak the demineralisation cartridge in a bowl of water
for at least 24 hours before using it. The resin has to
absorb water to achieve full performance.
• On average the demineralisation cartridge should be
replaced every 2 – 3 months. This interval can be
shorter or longer depending on the hardness of your
water.
• Read the instructions under «Filling the Tank» for filling
the water tank (12).
• Place the water tank onto the base and insert the mist
outlet (13).
• Insert the plug into the mains socket and switch on
the appliance using the on/off switch (15).
• The appliance will reach full capacity about 10 to 15
minutes after been switched on.
• Make sure that the power cord is not pinched any-
where (9). Do not operate the appliance if the cord is
damaged (2).
18

Description of the appliance

Mist outlet (rotating)
Water tank
Evaporation chamber
Demineralisation cartridge
Water tank cap
Control panel
Lower part

Filling the tank

Always switch off the appliance before removing
the water tank. Do not reach inside the nebuliser
space while the appliance is running!
Do not operate the appliance when the water tank is empty!
When the water reaches the minimum level, the unit swit-
ches off automatically.
• Make sure that there are no foreign objects inside the
water tank.
• Remove the water tank cap from the tank (11) (War-
ning: mist outlet is loosely inserted!). Fill the tank with
clean, cold tap water (12). Close the cap of the water
tank securely! Place the water tank onto the base and
insert the mist outlet (13). Do not add any additives to
the water (14)!
• Insert the plug into the power socket and switch on the
appliance (15).
Brush
Ionic Silver Stick
®
Membrane
Nebuliser space

Publicidad

Tabla de contenido
loading

Tabla de contenido