Description Of The Appliance; Putting Into Operation - Boneco U7137 Instruciones Para El Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54

Description of the appliance

Vapour outlet (rotating)
en
Evaporation chamber
Brush
Membrane
Water-level sensor
Control panel
Main body
Unpacking
• Carefully remove the humidifier from the box.
• Important: the vapour outlet is stowed in a red bag
in the cardboard insert. Make sure that you take the
vapour outlet from the packaging.
• Remove the plastic bag from the humidifier.
16
RZ_BD_Ultrasonic 7137/38.indd
Demineralisation cartridge
• Observe the information given on the rating plate about
the mains supply.
• Use the original packaging for storing the appliance if
you do not use the humidifier all year round.
16

Putting into operation

Finding the ideal location for your humidifier
• Do not place the humidifier directly next to a heating
element or on a floor with floor heating. The moisture
of the mist can damage the floor surface (6) (see
Safety Instructions).
• The vapour outlet must not be pointed directly at plants
or other objects. Keep distance of at least 20inch) (11).
• The Ultrasonic should be placed in a higher position
(on a table, commode etc.)
Water tank
• Soak the demineralisation cartridge in the watertank
approx. 24 hours before using it. The resin has to
absorb water to reach high performance.
• On average the demineralisation cartridge should be
replaced every 2 – 3 months depending on your water
hardness. Some areas may need to replace the cart-
ridge sooner some may last longer. See «Replacement
of the demineralisation cartridge».
• Read the instructions under «Filling the Tank» for
Water tank cap
putting water in the humidifier.
• Place the water tank on the base and insert the vapour
outlet.
• Insert the plug into the socket and switch on the
appliance using the on/off switch (16).
• About 10 to 15 minutes after having been switched on
Reservoir
the device will reach is full power.
• Make sure that the cable is not pinched anywhere
(8 – 9). Do not operate the humidifier if the cable is
Power cord
damaged (2).
Air inlet
18.7.2005, 10:48 Uhr

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

U7138

Tabla de contenido