Putting Into Operation; Description Of The Appliance; Filling The Tank - Boneco U7145 Instrucciones Para El Uso

Unpacking
• Carefully remove the unit from its box.
• Remove the unit from the plastic bag.
• Review the information given on the rating plate about
en
the mains supply.
• Use the original packaging for storing the appliance if
you do not use it all year round.

Putting into operation

Find the ideal location for your appliance:
• Do not place it directly next to a radiator or on a
floor with floor heating. The moisture of the mist can
damage the floor surface (6 and 7) (see Safety In-
structions).
• The mist outlet must not be pointed directly at plants or
other objects. Keep a distance of at least 50 cm) (10).
• Soak the demineralisation cartridge in a bowl of water
for at least 24 hours before using it. The granules have
to absorb water to reach full performance.
• On average the demineralisation cartridge should be
replaced every 2 – 3 months. This interval can be
shorter or longer depending on the hardness of your
water.
• Read the instructions under «Filling the Tank» for filling
the water tank (12).
• Place the water tank onto the base (13).
• Insert the plug into the mains socket and switch on
the appliance using the on/off switch (15).
• The appliance will reach full capacity about 10 to
15 minutes after being switched on.
• Make sure that the power cord is not pinched any-
where (9). Do not operate the appliance if the cord is
damaged (2).
20

Description of the appliance

Mist outlet (rotating)
Water tank
Evaporation
chamber
Demineralisation cartridge
Water tank cap
Ionic Silver Stick ®
Control panel
Main body

Filling the tank

Always switch off the appliance before removing
the water tank. Do not reach inside the nebuliser
space while the appliance is running!
To protect health safety and proper humidifier
function use only clean, contamination-free,
cold, fresh tap water in your humidifier. If your
water source is contaminated or if you are uncertain of its
safety use distilled water.
Do not operate the appliance when the water tank is empty!
When the water reaches the minimum level, the unit swit-
ches off automatically.
• Make sure that there are no foreign objects inside the
water tank.
• Remove the water tank cap from the tank (11). Fill the
tank with clean, cold tap water (12). Close the cap of
the water tank securely! Place the water tank onto the
base (13). Do not add any additives to the water (14)!
• Insert the plug into the power socket and switch on the
appliance (15).
Brush
Membrane
Nebuliser space