Galletti EVO Manual De Instalacion Y Uso página 31

CHANGING OPERATING MODE
To change the operating mode (Cooling/Heating) press the
MODE key from the main screen.
TURNING THE ECONOMY FUNCTION ON/OFF
To turn the ECONOMY function on it is necessary to view the
main screen. From here:
press the UP/DOWN keys to scroll through the screens
until you get to the "Turning the economy function On"
mask;
press the SET key to enter edit mode;
press the UP/DOWN keys to turn the function on/off and
press the SET key again to confirm;
press the ON/OFF key to go back to the main screen.
If the function is on, the economy symbol will appear in the
main screen.
ENABLING/DISABLING ELECTRIC HEATER
OPERATION
To enable/disable electric heater operation (if installed and
configured) you must go to the main screen. From here:
press the UP/DOWN keys to scroll through the screens
until you reach the 'turning the heater on' mask;
press the SET key to enter edit mode;
press the UP/DOWN keys to enable/disable the function
and press the SET key again to confirm;
press ON/OFF to go back to the main screen.
If the electric heaters are enabled (and configured correctly
in the CONFIGURATION MENU) the heater symbol will appear
on the main screen; it will flash if the heaters are not running,
or it will appear steady if the heaters are running.
EN
5
Controller for units
OPERATION MANUAL
IT IS strictly forbidden to reproduce this manual, even partially
ENABLING/DISABLING
TEMPERATURE CONTROL
To enable/disable the minimum room temperature control
function it is necessary to go to the main screen. From here:
press the UP/DOWN keys to scroll through the screens
until you reach the 'Turning the minimum temperature
control on' mask;
press the SET key to enter edit mode;
press the UP/DOWN keys to enable/disable the function
and press the SET key again to confirm;
use ON/OFF to go back to the main screen.
If the function is on, the minimum temperature symbol will
appear in the main screen.
TURNING AMBIENT HUMIDITY CONTROL ON/
OFF
To turn the ambient humidity control on/off you must go the
the main screen and there must be a humidity probe. From
here:
press the UP/DOWN keys to scroll through the screens
until you get to the "Turning the humidity control on" mask;
press the SET key to enter edit mode;
press the UP/DOWN keys to enable/disable the function
and press the SET key again to confirm;
use ON/OFF to go back to the main screen.
CHANGE THE HUMIDITY SET
To change the value of the ambient humidity set you must
go back to the main screen and have turned the ambient
humidity controller on. From here:
press the UP/DOWN keys to scroll through the screens
until you get to the "Humidity setpoint" mask;
press the SET key to enter edit mode;
press the UP/DOWN keys to enable/disable the function
and press the SET key again to confirm;
press ON/OFF to go back to the main screen.
EVO
MINIMUM ROOM
FC66003554
Rev 00