Maytag MDB-4 Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Adjustable rack
(select models)
The Adjustable Upper Rack (select
models) and Adjustable Middle Rack can
be raised or lowered to accommodate taller
plates, platters, pans, etc. in the upper,
middle or lower racks. Full size dinner
plates can be loaded in the upper rack if it
is in the lower position.
Removing the upper and
middle racks
The racks can be removed when tall or
oversized items need to be loaded into the
middle or lower rack. Unload the rack prior
to removing.
TO REMOVE:
Roll the rack 1/3 to 1/2 of the way out.
Remove the plastic rack stop from the
end of each track. To remove each
plastic rack stop, push inward
To lower the rack:
Pull the rack fully out.
Place hands on each adjuster.
Press down on the top blue button and
push down (the button will slide
towards the center of the rack).
The rack will come to a stop when it is
in position.
To raise the rack:
Pull the rack fully out.
Place hands on each adjuster.
Lift up both sides until rack comes to a
stop.
(towards the rack) on the ridged area
of the rack stop. The rack stop will
snap open and can be easily removed
by pulling straight out. Take care to
support the track while removing rack
stops.
Roll the rack all the way out of the track
and remove from the dishwasher.
Reverse the above procedure to
replace the rack into the dishwasher.
NOTE
The dishwasher will not operate
correctly if the rack wash arm
connection is not aligned with one
of the water inlet holes on back
wall.
Rack Stop
4

Publicidad

Tabla de contenido
loading

Tabla de contenido