SPIT P18 Manual Original página 20

English
20
Start-up
Charge battery.

Insert battery.

-WARNING-
Use only original SPIT batteries with the
voltage given on the type plate of your
machine.
Use of any other batteries may lead to the risk of
injury or fire.
Use only the battery chargers and batteries
listed in the illustrated instructions.
Only these battery chargers and batteries are
tailored specifically to your power tool.
Battery
-NOTE-
The battery is supplied
Completely the first time.
Battery with lithium-ion technology
Total discharge protection
The "Electronic discharge protection function"
protects the LI battery against total discharge.
Should the battery discharge, the power tool is
switched off by a protective circuit. The power
tool stops operating.
-WARNING-
Do not continue to press the On/Off switch
II after an automatic shutdown of the power
tool.
The battery could be damaged.
Temperature-dependent overload protection
The LI battery is equipped with NTC temperature
monitoring which only permits charging within a
temperature range of 0 °C - 50 °C. This ensures
long battery service life.
Battery care
Never charge batteries at temperatures lower
than 0°C or higher than 50°C.
Never charge batteries in an environment with
high air humidity or a high ambient temperature.
If the batteries are not used for a prolonged
period, store them partially charged in a cool
place.
Battery charge level indicator
The three LEDs on the charge level indicator 3
show the level of the charge in the battery.
Press the button II to display the charging status.
The charge level indicator LED goes out
automatically after approx. 2 seconds.
If one of the LEDs flashes when the button II is
pressed, the battery needs charging!
If none of the LEDs lights up when the button II is
pressed, the battery is faulty and must be
replaced.
3 LED : charged battery between 70-100%
2 LED : charged battery between 30-69%
1 LED : charged battery between <30%
partially charged.
Battery charger
Before putting the tool into operation, check that
the mains voltage and frequency on the type
plate match the details of your mains supply.
Mains cable charger
Fixed power supply
Damaged mains cables must not be used. They
must be replaced immediately by an expert
technician.
Specified conditions of use for the
charger
The charger is intended solely for charging SPIT
batteries.
Ensure that you use the right batteries for the
charger, see "Appropriate batteries".
SPIT P18 Lithium
Observe correct mains voltage!
Fixed power supply