Maintenance And Service - SPIT P18 Manual Original

English
22
Changing the speed
The On/Off switch II can be used for infinitely
variable speed control. With increased pressure,
the speed increases.
Selecting the rotary direction
Only operate the rotational direction switch I when
the machine is at a standstill!
Set the required rotary direction.

Clockwise rotation:
For fixing.
Anticlockwise rotation:
For removing.
Important! Always press
direction switch I up to the stop on the housing, i.
e. until you feel it engage. When the rotational
direction switch I is in its middle position, the
machine cannot be switched on.
Changing the tool
Remove the battery from the device before
undertaking any work on the device.
This safety measure prevents accidental starting of
the power tool.
Wear safety gloves when changing the tool.
The tool insert can become very hot after working
for long periods and/or the cutting edges of the
tool insert are sharp.
Bit
To replace the bit IV, pull off the depth stop 7. The
bit can then be pulled from the bit holder and a
new bit inserted. Replace the depth stop 7.
After working for a long time at low speed, you
should run the power tool for approx. 3 minutes
at maximum speed in idle to allow it to cool.
Make sure that the screwdriver and screw
correspond in size and shape.
Optimal screwdriver is achieved when the
screwing device is fixed securely in the screw
head.
Clutch
The screw can be placed on the still standing bit
while the machine is running. The clutch
engages only after applying pressure while
screwing. When the depth stop comes to rest on
the surface, the clutch is disengaged. The bit again
comes to a stop.
5 - Tools and accessories
Belt hook
The belt clipholder 5 can be used to clip the
power tool to a belt, for example. This leaves
both your hands free, while the power tool
remains within easy reach at all times.
Special accessories
Do
manufacturers, as these are not tested by SPIT.
It can be dangerous to use such accessories.
To
accessories recommended by SPIT.
the rotational

6. Maintenance and service

Maintenance and cleaning
Remove the battery from the device before
undertaking any work on the device.
This safety measure prevents accidental starting of
the power tool.


Service
After heavy use over a long period, the machine
should be taken to a SPIT service location for
inspection and thorough cleaning. You will find a
list of service centres on the back of these
operating instructions.
Environmental Protection
Recycle raw materials instead of disposing them
as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling. The plastic components are
labelled for categorised recycling.
SPIT P18 Lithium
not use accessories
avoid injury and damage,
Keep the machine and ventilation slots
clean.
Regularly wipe off the plastic parts which
are accessible from the outside using a
cloth without cleaning agent.
Do not dispose of electric tools toge
ther with household waste material!
made by other
use only