Ryobi APR04 Manual De Utilización página 17

WARNING
Beware of objects thrown by the cutting means. Always
wear safety goggles or safety glasses with side shields
and a full face shield when operating this product.
We recommend Wide Vision Safety Mask for use
over eyeglasses or standard safety glasses with side
shields. Always use eye protection which is marked to
comply with EN 166.
FEATURES
Before attempting to use this product, familiarize yourself
with all operating features and safety rules.
WARNING
Do not allow familiarity with the product to make you
careless. Remember that a careless fraction of a
second is suffi cient to infl ict serious injury.
WARNING
Do not attempt to modify the product or create
accessories not recommended for use with the product.
Any such alteration or modifi cation is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
DESCRIPTION
1. BAR
2. CHAIN
3. CHAIN OILER TANK CAP
4. GEAR CASE
5. PRUNER ATTACHMENT SHAFT
6. TOE
7. COMBINATION WRENCH
8. HANGER CAP
9. KNOB
10. COUPLER
11. POWER HEAD SHAFT
12. BUTTON
13. GUIDE RECESS
14. POSITIONING HOLE
15. SHOULDER STRAP HANGER
16. STRAP HANGER
17. BOLT
18. LEFT HAND CUTTERS
19. NUT
20. CUTTING GUIDE
21. BAR NUT
22. DRIVE CASE COVER
English(Original instructions)
23. CHAIN TENSIONING PIN
24. BAR STUD
25. SPROCKET
26. BAR STUD SLOT
27. CHAIN TENSIONING PIN HOLE
28. CHAIN ROTATION
29. CHAIN TENSIONING SCREW
30. RIGHT HAND CUTTERS
31. CHAIN OILER TANK
32. DEPTH GAUGE SETTING
33. HANGER HOLE
34. TOP PLATE
35. RIVET HOLE
36. HEEL
37. GULLET
38. CUTTING CORNER
39. SIDE PLATE
40. DEPTH GAUGE
ASSEMBLY
JOINING THE POWER HEAD TO THE ATTACHMENT
See Figure 1 and 2.
Never attach or adjust any attachment while power
head is running. Failure to stop the engine may cause
serious personal injury.
The attachment connects to the power head by means of
a coupler device.
1. Loosen the knob (9) on the coupler (10) of the power
2. Push in the button located on the attachment shaft.
3. Tighten the knob securely.
15
WARNING
head shaft and remove the hanger cap (8) from the
attachment shaft (5).
Align the button with the guide recess (13) on the
power head coupler and slide the two shafts together.
Rotate the attachment shaft until the button locks into
the positioning hole (14)
Note: If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is
locked into place.
Note: The pole pruner attachment should only be
operated with the blade in a vertical position. Use
only the specified positioning hole for this pole pruner
attachment.