Motorola D810 serie Manual De Instrucciones página 25

D811_IFU_EN.fm Page 25 Friday, September 7, 2007 7:37 PM
• To wall-mount the charger, drill two holes in the wall 4cm
apart horizontally using an 8mm drill bit.
2. Insert the wall plugs if necessary, then insert the screws
leaving about 5mm protruding from the wall on which to
hang the phone.
Wall plug
Wall
Wall mounting
3. Pull the base/charger out of the stand and slot the holes on
the back of the base over the screw heads and gently pull
the base/charger down to make sure it is securely in place.
Screw
XXmm
25