Symbols Used; In The Documentation; Warning Notices - Structure And Meaning; Symbols In This Documentation - Bosch VLS 3132 H Funcionamiento Inicial

en 16 | VLS 3132 H | Symbols used
1.

Symbols used

1.1

In the documentation

1.1.1

Warning notices - Structure and meaning

Warning notices indicate hazards and their
consequences for the user or surrounding persons.
Warning notices also describe the measures for
preventing these hazards. The signal word has a
crucial importance. It indicates the probability of
occurrence and the severity of the hazard in case of
non-compliance:
Signal Probability of
word occurrence
DANGER Immediate impending
danger
WARNING Possible impending
danger
CAUTION Possible dangerous
situation
Below you will see an example of the "Live parts"
warning notice by way of example, with the signal word
DANGER:
DANGER – Exposure of live parts on
opening the KTS 670!
Risk of (fatal) injury or heart failure
from electric shocks on contact with live
components.
¶
Work on electrical installations or
equipment is only to be performed by
qualified electricians or trained personnel
under the guidance and supervision of an
electrician.
¶
Disconnect KTS 670 from the mains
before opening.
1.1.2

Symbols in this documentation

Sym- Designation Explanation
bol
Attention Warns about possible property damage.
!
Information Practical hints and other
i
useful information.
1. Multi-step Instruction consisting of several steps
2. operation
One-step Instruction consisting of one step.
e
operation
Intermediate An instruction produces a visible

result intermediate result.
Final result There is a visible final result on
"
completion of the instruction.
|
1 689 978 571 2011-06-01
Severity of danger if
instructions not observed
Death or severe injury
Death or severe injury
Minor injury
1.2

On the product

!
Observe all warning notices on products and ensure
they remain legible!
DANGER – Exposure of live parts on
opening the VLS 3132 H!
Risk of (fatal) injury or heart failure
from electric shocks on contact with live
components (e.g. master switch, printed
circuit boards).
¶
Work on electrical installations or
equipment is only to be performed by
qualified electricians or trained personnel
under the guidance and supervision of an
electrician.
¶
Disconnect the VLS 3132 H from the mains
before opening.
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
The transporting of persons on the lifting
tables or in the vehicle is prohibited.
Notes on load distribution
In the case of maximum load, the front/rear load
distribution must not exceed 3 : 2 (see image in quick
user guide).
Quick user guide
R
Safety instructions
R
Operation
R
Controls
R
Maintenance work
R
Load distribution
R
Approach direction
Robert Bosch GmbH