Introduction; Validity Of This Document; Assembly By Third Parties; Transportation Information - Bosch VLS 3132 H Funcionamiento Inicial

Plataforma elevadora de pantógrafo doble
Ocultar thumbs Ver también para VLS 3132 H:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2.

Introduction

2.1

Validity of this document

This document describes the installation and
Initial commissioning of the Bosch lifting platform
VLS 3132 H.
This model is a double scissor lifting platform with
electro-hydraulic drive. The lifting platform has a load
bearing capacity of 3200 kg.
i
The operating principle and function of the lifting
platform are described in the original instructions.
2.2

Assembly by third parties

The content of these assembly instructions must be
observed along with the information in the supplied
original instructions. If the lifting platform is not
installed by Bosch customer service or a service
outlet authorized by Bosch, the lifting platform must
subsequently undergo a safety acceptance test
performed by Bosch customer service or a service
outlet authorized by Bosch.
This safety acceptance test comprises the following:
R
Electrical function test and trial run as per BGG 945.
R
Examination of individual assemblies and
components.
R
Entry in test log book according to BGG 945-1.
R
Personnel instruction (safety and operation).
i
Failure to complete this safety acceptance test will
invalidate all warranty claims as well as our liability.
Robert Bosch GmbH
Introduction | VLS 3132 H | 17
2.3

Transportation information

The lifting platform is delivered as follows:
Packing unit
Dimensions
1 x pallet
1660 x 680 x 790 mm
(5.5 x 2.3 x 2.6 feet)
The user must provide a forklift truck for internal
transport. The center of gravity and lashing points are
marked on the packaging.
Fig. 1:
Center of gravity of packaging (example)
2.4

Preparations by the user

2.4.1

Space requirements

Fig. 2:
Recommended workplace dimensions
Arrow: direction of travel
Dashed line: danger zone
There must be a clearance of at least 1 meter between
the lifting platform and fixed elements (e.g. wall) in all
lifting positions.
There must be sufficient space at the ends of the lifting
platform for driving vehicles on and off.
Recommended room height: min. 4 m.
en
Weight
750 kg
(1654 lb)
|
1 689 978 571
2011-06-01

Publicidad

Tabla de contenido
loading

Tabla de contenido