Stihl HSA 66 Manual De Instrucciones página 25

Charge Times
AL 100
with AP 80:
– up to 80 % capacity: 70 min
– up to 100 % capacity: 100 min
with AP 115:
– up to 80 % capacity: 110 min
– up to 100 % capacity: 140 min
with AP 160:
– up to 80 % capacity: 150 min
– up to 100 % capacity: 165 min
with AP 180:
– up to 80 % capacity: 160 min
– up to 100 % capacity: 210 min
AL 300
with AP 80:
– up to 80 % capacity: 25 min
– up to 100 % capacity: 50 min
with AP 115:
– up to 80 % capacity: 25 min
– up to 100 % capacity: 55 min
with AP 160:
– up to 80 % capacity: 35 min
– up to 100 % capacity: 60 min
with AP 180:
– up to 80 % capacity: 40 min
– up to 100 % capacity: 70 min
HSA 66
AL 500
with AP 80:
– up to 80 % capacity: 25 min
– up to 100 % capacity: 50 min
with AP 115:
– up to 80 % capacity: 20 min
– up to 100 % capacity: 25 min
with AP 160:
– up to 80 % capacity: 35 min
– up to 100 % capacity: 60 min
with AP 180:
– up to 80 % capacity: 25 min
– up to 100 % capacity: 30 min
Cutting Attachment
Tooth spacing: 1.2 in (30 mm)
Stroke rate (off load): 3,000 rpm
Cutting length: 20" (500 mm)
Sharpening angle to
horizontal: 35°
Weight
without battery, with cutting attachment,
without blade scabbard
HSA 66: 6.8 lbs (3.1 kg)
Transporting
STIHL batteries comply with the
requirements set forth in UN-Manual
ST/SG/AC.10/11/Rev.5/Part III,
Subsection 38.3.
Commercial air, vessel and ground
transportation of lithium ion cells and
batteries is regulated. The battery is
classified as a UN3091, Class 9,
packaging group 2 product. Shipping it,
either as a complete tool or the battery,
requires compliance with all applicable
shipping regulations. Check with the
ground, vessel, air cargo or passenger
airline to determine if transport is
prohibited or subject to restrictions or
exemptions prior to shipping or travel.
Normally, no further conditions have to
be fulfilled by the user to transport
STIHL batteries by road to the power
tool's operating site. Check and comply
with any special regulations that may
apply to your situation.
FCC 15 Compliance Statement for
power tool and charger
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
this device may not cause harmful
–
interference
this device must accept any
–
interference received, including
interference that may cause
undesired operation
Note: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
English
23