Switching On - Stihl HSA 66 Manual De Instrucciones

Red flashing light ...
... indicates the following:
No electrical contact between
–
battery and charger – remove and
refit the battery
Malfunction in battery – see also
–
"Light Emitting Diodes (LEDs) on
Battery".
Malfunction in charger – have it
–
checked by a servicing dealer.
STIHL recommends a STIHL
servicing dealer.
HSA 66

Switching On

A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
If necessary, remove the cover from
N
the battery compartment before
fitting the battery, i.e. depress both
locking tabs to unlock and remove
the cover.
Fitting the Battery
1
Insert the battery (1) in the power
N
tool – the battery slides into the
compartment – press it down
carefully until it snaps into position –
the battery must be flush with the
top of the housing.
Switching on the Machine
Make sure you have a secure and
N
firm footing.
Stand upright – hold the power tool
N
in a relaxed position.
Make sure the cutting attachment is
N
not touching the ground or any other
objects.
Hold the power tool with both hands
N
– one hand on the control handle –
one hand on the loop handle.
2
Unlock the power tool by moving the
N
retaining latch (2) to ‚.
3
4
5
Push the switch lever (3) against
N
the loop handle and hold it there.
Push down the trigger switch
N
lockout (4) and depress the trigger
switch (5) and hold them in that
position.
The motor runs only if the retaining
latch (2) is on ‚ and the switch
lever (3) and trigger switch (5) are
operated simultaneously.
English
17